Kathrein UFC 861si - Manual (Page 8)

8
CONNECTION AND SETUP
The following section is intended specifi cally for specialist dealers. You need not refer to this section unless
you are carrying out the installation yourself.
The “Connection Examples” section provides a sample confi guration.
Do not connect the receiver to the power supply until all installation work has been properly carried out.
Refer to the information in the “Safety Instructions” section.
CONNECTING THE UNIT (SAT-IF CONNECTIONS)
Connect the RF 1 input of the receiver to the antenna socket.
Use a coaxial cable with a standard IEC connector.
If the IEC connector is not yet fi tted to the cable, strip the insulation from the cable as shown in the following
illustration and carefully fi t the connector on to the end of the cable so that it is securely fi tted.
RF(HF) CONNECTION
When fi tting the connector, make sure that no strands from the braiding touch the inner
conductor, otherwise a short circuit will occur.
The quality of the reception signal depends on this connection!
Bend back Lengthwise slits (3x) Screw together