Liebert GXT2-6000RTL630 - Manual (Page 19)

Installation and Configuration
15
1. Remove the 3U battery access panel on the front of the GXT2-6000RTL630 by loosening the two
captive screws located between the bezels (see illustration at left).
2. Once the captive screws are loosened, tip the panel forward and lift to remove it from the main
cabinet.
3. Unpack the GXT2-240BATKIT battery assembly.
4. Line up and slide in the battery pack while holding the internal connector out of the way.
5. Connect the electrical cables to each battery pack with the two slotted battery connectors.
6. Install the battery retaining brackets supplied in the accessory box.
7. Install the battery access panel and tighten the captive screws.
5.3 Connect the Internal Batteries Using the External Connector
The connector attaches to the UPS in both the open and closed position using two screws. The picture
on the left shows the connector in the open position, as shipped.
When the UPS is installed, remove the two screws to release the connector. Plug the connector into
the socket. The internal batteries are now connected to the UPS electronics. Install the two screws to
secure the connector in the closed position.
5.3.1 Storage
If the UPS is to be shipped or stored for an extended time, the connector should be removed and
attached in the open position, as shown above. This will minimize any standby current drain on the
batteries.
5.4 Connect Input/Output Power
The Power Distribution box is shipped separately for easier handling of the UPS while the UPS is
being placed in its final position.
! UPStation GXT
AC INPUT
- +
BATTERY UPS ON BYPASS
! UPStation GXT
AC OUTPUT BATTERY UPS ON BYPASS
Retaining
bracket
(one of two)
Retaining screw Battery Connectors
Battery Door Captive Screws
3U Battery Access Door and
Battery Bezel
Remove these screws
to release connector