Lindy 25010 - Manual (Page 47)

2.11 System Setup
The System Setup page provides the management information of the switch. This page, shown as
below, can be activated by clicking the System Setup menu under the System section.
The following parameters can be configured / displayed:
„ Model Name – the model name of this switch (read-only)
„ Chip Version – the switch chip version of this switch (read-only)
„ Firmware Version – the current version of the firmware existing on the switch (read-only)
„ DHCP Client – DHCP client status
„ IP Address – the IP address to manage this switch through the configuration port.
„ Subnet mask – the network mask to identify the sub-network address
„ Gateway – the IP address of the default gateway to reach to the outside network
„ MAC address – the MAC address for the configuration port interface (read-only)
„ ARL Aging – the aging time of dynamic ARL entry in address table
46