Lindy 25010 - Manual (Page 55)

2.14 Command Line Interface (CLI)
In addition to the web management, the 24G web smart switch also provides a serial interface
(RS-232) as a console port on the rear panel to manage the switch for system setup, user
management, reset system and firmware updates through the command line interface (CLI). We
recommend you use Windows Hyper Terminal. This section will show you how to setup and use
Hyper Terminal to manage this switch.
2.14.1 Hyper Terminal Setup Options
„ Baud Rate ：19200 bps
„ Data Bits ：8
„ Parity ：None
„ Stop bits ：1
„ Flow control ：None
2.14.2 Switch Management Commands In Console
„ Login System
After the system has started, the following prompt will be displayed in Hyper Terminal.
The user needs a valid username and password to login to this system. The username and
password in CLI are the same as the ones used for login access through the web page.
Please enter the correct username now.
After entering the username, the following prompt will be displayed. The user should enter
the correct password now, and then begin to manage the 24G web smart switch.
54