Lindy 25010 - Manual (Page 54)

2.13 Reset System
This switch can be rebooted or reset to default configurations through the web page.
Click Reboot System menu to reboot the system.
Click Reset System menu to reset the system back to factory settings.
¾ Reboot System – Just reboot the system. All configuration settings will be retained to the latest
changes before the reboot procedure. If you want to keep your configuration, select this option.
¾ Reset System – Reset all configurations (including the username, password and IP address;
only the MAC address won’t be changed) to default settings before rebooting the system. This
means that any customized configurations will be lost and can’t be recovered.
The 24G web smart switch also provides an alternative to the Reset System option by using the
Reset button on the rear panel:
¾ While the system is running (the DIAG LED indicator is ON), pressing and holding the Reset
button (for over 5 seconds) until the DIAG LED indicator stars to flash will activate the
Write Default procedure.
After the procedure mentioned above is done, the switch will be automatically rebooted and
initialized using the default settings. .
System rebooting will take about 10 seconds. You need to login to the system again to enter the web
pages for continuous configurations.
53