Rotor lamination. see figure f.11 and the, Troubleshooting & repair – Lincoln Electric CLASSICII SVM125-A User Manual
Page 82
TROUBLESHOOTING & REPAIR
F-32
F-32
CLASSIC II
ALTERNATOR ROTOR REMOVAL
AND REPLACEMENT
(continued)
FIGURE F.11 – CASE FRONT REMOVAL PREPARATION
REMOVE
FASTENERS
BATTERY
RETAINER
FASTENERS
TERMINAL
CABLES
PROCEDURE
1. Turn the engine off.
2. Unlatch, lift and secure the right side door.
There are latches on both sides.
3. With the 1/2" wrench, disconnect the negative
battery cable.
4. With 3/8" socket wrench, remove the left case
side.
5. With the 1/2" wrench, remove the exhaust
pipe rain cap.
6. With the 1/2" and 9/16" wrenches, remove the
four nuts and bolts securing the case top and
door assembly. Remove the case top and
door assembly.
See Figure F.11 for steps 7 - 10.
7. With the 1/2" wrench, remove the battery
terminal cables. Remove negative cable
first. Then remove the two nuts and split
ring lock washers holding the battery retain-
er clamp. Remove battery.
8. With the 1/2" wrench, remove the six bolts,
nuts and lock washers holding the case front
to the frame ( three on each side).
9. With the 5/16" nut driver, remove the two
sheet metal screws from the right side of the
case front. These screws hold the output
terminal assembly to the case front.
10. With the 3/8" wrench remove the screw from
the bottom center of the case front holding
the front to the frame.