Perle Systems IOLAN CSS - Manual (Page 123)

Network Commands 119
VPN Exceptions
Show LT2P
VPN Exceptions
VPN exceptions allows specific hosts or any host in a network to connect to the IOLAN outside of a
VPN tunnel.
Add VPN Exception
Set VPN Exception
authentication-type
Specify the authentication method that will be used for the L2TP tunnel.
Data Options: CHAP, PAP, Both
Default: Both
Description Shows the L2TP settings.
User Level Admin
Syntax
show l2tp
Description Adds a VPN exception.
User Level Admin
Syntax
add vpn-exception network-ip <ipv4_net_ip> <network_subnet>|
<ipv6_net_ip> <prefix_bits>
add vpn-exception host-ip <ipv4/ipv6_address>
Options network-ip <ipv4_net_ip> <network_subnet>|<ipv6_net_ip> <prefix_bits>
The network address that will communicate with the IOLAN outside of the VPN tunnel.
If the address is IPv4, you can supply the subnet mask for the network (the default is
0.0.0.0). If the address is IPv6, you can supply the prefix bits for the network (the
default is 64, the range is 0-128).
host-ip <ipv4/ipv6_address>
The IP address of the host that will communicate with the IOLAN outside of the VPN
tunnel.
Field Format: IPv4 or IPv6 address
Description Configures an existing VPN exception.
User Level Admin
Syntax
set vpn-exception <config_vpn_except>
network-ip <ipv4_address> <network_subnet>|
<ipv6_address> <prefix_bits>
set vpn-exception <config_vpn_except> host-ip <ipv4/ipv6_address>
Options network-ip <ipv4_net_ip> <network_subnet>|<ipv6_net_ip> <prefix_bits>
The network address that will communicate with the IOLAN outside of the VPN tunnel.
If the address is IPv4, you can supply the subnet mask for the network (the default is
0.0.0.0). If the address is IPv6, you can supply the prefix bits for the network (the
default is 64, the range is 0-128).