Perle Systems IOLAN CSS - Manual (Page 69)

IOLAN SDS/SCS/STS CLI Reference Guide, Version 3.6 67
Line Commands
Chapter 4
4
This chapter defines all the CLI commands associated with configuring the IOLAN’s line parameters.
1-Port vs. 2-Port+ Line Commands
If you are using a 1-port IOLAN, the admin user does not have the option of using the number or all
(*) options in the line commands, as there is only one line. In a 2-port+ IOLAN, the admin user must
specify
. (current line), < number > (line number), or * (sets value for all lines) when configuring
lines.
Line Commands
Set Line
Description Configures line parameters. The set line command does not work on modem
ports/lines on models that have an internal modem.
User Level Normal, Admin
Syntax
set line . [data-bits 5|6|7|8]
[connection-method dial-in|dial-out|dial-in-out|direct-connect|
ms-direct-host|ms-direct-guest]
[idle-timer <0-4294967>] [line-name <name>]
[modem-name <config_modem>] [pages 1|2|3|4|5|6|7]
[parity none|even|odd|mark|space] [phone-number <phone_number>]
[rev-sess-security on|off] [sess-timer <0-4294967>]
[stop-bits 1|2|1.5] [termtype wyse60|vt100|ansi|dumb|tvi925|
ibm3151te|vt320|hp700|term1|term2|term3]
Admin User
Only set line .|<number>|* ... [mode enabled|disabled] [break on|off]
[map-cr-crlf on|off] [data-logging on|off] [flowin on|off]
[flowout on|off] [hotkey-prefix <00-7f>] [initial cli|menu]
[keepalive on|off] [lock on|off]
[microsoft-sac-support on|off] [motd on|off]
[multisessions <integer>] [reset on|off] [dial-timeout <number>]
[dial-retries <number>] [user <name>] [nouser]
[line-termination on|off] [internet-address <IPv4_address>]
Options mode
Enables/disables a line (available only on 2-port+ models). The default is enabled.
data-bits
Specifies the number of bits in a byte. The default is 8 .