Paradyne U8777 - Manual (Page 92)

9. Transferring Firmware and Configurations Using TFTP
9-2 May 2002 8700-A2-GB20-40
Procedure
To download firmware:
1. Position the cursor in the Image File Name field. Type the name of the file to
be downloaded.
The file name must be a regular path name expression of directory names
separated by a forward slash (/) ending with the file name. The total path
name length can be up to 128 characters.
2. Position the cursor in the TFTP Server IP Address field. Enter the TFTP server
IP address or M1 for the MCP FFS.
The first three digits of the IP address cannot be 000 or greater than 223.
3. For an LTU, go to Step 4 . For an NTU, position the cursor in the Destination
field. Use the spacebar to select a network destination for the TFTP server.
4. Position the cursor in the Immediately Apply Download field. If you would like
the download to be effective immediately, select Yes.
5. Position the cursor at the Start Transfer field. Use the spacebar to select Yes.
Press Enter.
When the data transfer is complete:
— If you selected Yes in Step 4 , the card is reset.
— If you selected No, the Transfer Status field changes to Completed
successfully .
If you specified No (the default) in the Immediately Apply Download field in
Step 4 , you must now apply the download.
main/control/apply_download
Model: 87xx
APPLY DOWNLOAD
Switch To Code Revision A01.00.02: No
WARNING:
An answer of “yes” will cause the system
to reset as if it had been powered off and on!
-------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit
Select: Yes, No LOS at Net, Pt 1