Pentair Intellitouch ScreenLogic - Manual (Page 101)

91
IntelliTouch ScreenLogic User’s Guide
“Connecting Please Wait” message
If the Tablet has entered a suspend state, when you switch it back on, it will take a few seconds to reconnect to the
ScreenLogic wireless router. If it has trouble reconnecting, move closer to the wireless router. It the Tablet is still
non-responsive, hold the Suspend button for four seconds until the Tablet reboots. Wait a few seconds, and press
the Suspend button. The Tablet will restart an automatic start the ScreenLogic configuration program.
How do I make the panel brighter/darker?
Tablet: From the Control Panel (Start > Settings > Control Panel), tap on the Brightness icon. Choose the
Brightness tab and tap on the Bright and Dark buttons to increase or decrease the brightness of the display. You
may also be able to program some of the hard buttons on the device to perform this function (see Start > Settings
> Control Panel > Button Settings).
PDA: Tap Start > Settings > System. Tap the Brightness icon. Tap Dimmer or Brightness to adjust the contrast.
Tap OK to exit and save settings.
How do I switch the Tablet off?
To switch the Tablet off, briefly press the Suspend button on the left side of the unit. The screen will go dark almost
immediately, and all open applications will be retained for the next time you power on. Do not hold on to the
Suspend button for too long (4 seconds or more), under normal operating conditions, as this will power the unit off.
You may lose valuable user data unless you have previously saved this information.
My Digital Tablet will not switch on
Verify that you had pressed the Suspend button briefly. Ensure that the Digital Tablet has power. Plug the Digital
Tablet into the AC power adapter that shipped with the panel, and plug the unit into a wall outlet. Watch the battery
LED to ensure that it blinks slowly in Green color to indicate charging of the battery (the LED may also glow steady
Green if the battery is fully charged). Press the Suspend button on the left side of the panel. If you continue to have
trouble, contact Technical Support (see page viii).
My Digital Tablet will not switch off
I changed my mind immediately after recovering from Suspend mode and wish to put the
device into Suspend again. Why is it that the Suspend button appears nonresponsive?
Each time you recover from Suspend mode, it takes 10-15 seconds for the system to totally recover, although you
can see the display and use the system within 1-2 seconds. During this recovery period of 10-15 seconds, the
system will not be able to process any request to re-enter Suspend mode. As soon as the system has fully
recovered, a single Suspend request will be processed if a single or multiple Suspend requests were made during the
recovery period.