Pentair Intellitouch ScreenLogic - Manual (Page 70)

60
IntelliTouch ScreenLogic User’s Guide
Change the Pool and Spa Temperature
All pool and spa heat modes and temperature controls are located on the Main screen. The pool or spa will heat to
the settings specified on this screen.
Changing Pool Heat Settings
To raise the pool water temperature:
1. From the main screen choose Heater, Solar Preferred or Solar in the Heat Mode selection.
2. Tap the pool Warmer button. The pool will heat to the settings specified as indicated by the Set Point.
To lower the pool water temperature:
• Tap the Off button for Heat Mode or tap the Cooler button to change the new Set Point temperature.
Changing Spa Heat Settings
To raise the Spa water temperature:
1. From the main screen choose Heater, Solar Preferred or Solar in the Spa Heat Mode selection.
2. Tap the spa Warmer button. The pool will heat to the settings specified as indicated by the Set Point.
To lower the spa water temperature:
• Tap the Off button for Heat Mode or tap the Cooler button to change the new Set Point temperature.
Main Lights Screen
From the COLOR LIGHTS and INTELLIBRITE tabs you can control standard pool and landscape lights and
IntelliBrite LED lights which are displayed on the main Lights screen. For lights to display on the main lights
screen, circuits must first be assigned as “lights” in the “Setup Circuits (Step 2 of 5)” page of the Configurator
utility (see page 35).
A combination of standard and IntelliBrite pool and spa lights can be controlled from both the “Color Lights”
and “IntelliBrite” tabs. For example, you might have two Pentair SAm lights, two IntelliBrite LED lights in your
pool/spa. These lights can be controlled from the Lights screen using the special Color Set, Color Swim and
Color Sync lighting features in the “Color Lights” tab or control the IntelliBrite lights from the “IntelliBrite” tab
to select fixed colors or a color show mode.