Pentair Intellitouch ScreenLogic - Manual (Page 56)

46
IntelliTouch ScreenLogic User’s Guide
Setting up a Two-Speed Pump
Equipment circuits displayed on this screen will automatically switch a two-speed filter pump to high speed when
these circuits are switched on. For example you can have the Filter pump switch to high speed whenever the JETS
or CLEANER is on.
To assign a two-speed pump to a circuit:
1. Start the ScreenLogic Configurator and tap Configure IntelliTouch.
2. Tap Next on the General Setting page and on the Setup Circuits page. The Configure Other Equipment
(Step 3 of 5) page is displayed.
3. Scroll through the previously assigned circuit names to add
another circuit for switching filter pump to high speed. Select a
circuit to assign to a high speed pump from the Add a circuit
box. Continue to add another circuit. You can use a Feature
Circuit as one of the circuits which can switch the pump to high
speed (except for models i5 and i5S).
Note: With a dual equipment system i10+3D, one circuit
button is assigned to control the spa pump and the pool
pump. For more details, refer to “Configure Other
Equipment (Step 3 of 5),” page 43.
4. Repeat step 3 for each circuit requiring a two speed pump.
5. Tap Finish when done.
Setting up Additional Equipment
The following describes how to set up any special equipment that may be attached. Your system may or may not
have this equipment installed.
The following information describes:
• Setting up a two-speed pump - Setup circuits that switch the filter pump from low to high speed.
• Setup Solar equipment - Enable solar or heat pump.
• Cool-down cycle for the heater - Set a cool-down cycle for heaters that require it.
• Enable “Spa Manual Heat” control - Heats the spa using the Spa button on the ScreenLogic Main screen
or the spa-side control, even when the heater is set to OFF in the Heat screen. This lets the homeowner heat
the spa on-demand. Timed programs will not heat the spa.