Pentair Intellitouch ScreenLogic - Manual (Page 52)

42
IntelliTouch ScreenLogic User’s Guide
Creating Custom Names for Auxiliary Circuits
There are nearly 100 circuit names stored in the IntelliTouch software (see page 40). If you cannot find one to fit
your application you can create up to 20 custom names.
To create a custom circuit name:
1. Start the ScreenLogic Configurator and tap Configure IntelliTouch.
2. Tap Next on the General Setting page. The Setup Circuits (Step 2 of 5) page is displayed.
3. Select an AUX circuit from the main list.
4. Tap the Set Custom Names button. The Custom Names dialog is displayed.
5. Tap USERNAME-01 from the list. Enter the new circuit name in the box. The new name can be a maximum
of 11 characters. The Custom Names (USER NAME 01-20) can be found at the bottom of the circuit name
drop down box. If you are using the Tablet, use the virtual keyboard to enter the new name. For more
information about the virtual keyboard button, see page 11.
6. Tap Set Name to save the custom name. The new name is displayed in the Custom Names list.
7. Tap Done to save and close the dialog.
8. The custom name is displayed in the main Circuit Names lists and now can be used when assigning a new
circuit.
Display a Circuit Function Button on the Main Screen
An assigned circuit function can be displayed as a button on a ScreenLogic main screen. For more information
about displaying circuit buttons on the main screen, refer to “Setup circuits (Step 2 of 5),” page 35.
To display an assigned circuit button:
1. Start the ScreenLogic Configurator and tap Configure IntelliTouch.
2. Tap Next on the General Setting page. The Setup Circuits (Step 2 of 5) page is displayed.
3. In the list of assigned circuits, select the circuit you want to change.
4. Under ScreenLogic Display, in the Show with box, select where you want the button to appear, under Pool,
Spa or Water Features on the ScreenLogic Main screen. For example, if the AUX 2 circuit is assigned to a
Cleaner, selecting Pool from the “Display with” box will display a Cleaner button under the Pool button on the
ScreenLogic Main screen. Up to 20 buttons can be displayed under Water Features on the ScreenLogic
Main screen. Use the right arrow button to scroll through other assigned buttons.
5. Tap Finish when done to save the setting.
IntelliTouch Indoor Control Panel Circuit Names
Custom circuit names used in the Configurator utility need to be updated in the IntelliTouch Indoor Control Panel in
order for these names to display in the Indoor Control Panel.
To update the Indoor Control Panel to display the current circuit names:
1. Press Menu > Setup > Advanced > Circuit Names.
2. Select the new circuit name, then press the Exit button. The display will show the same circuit names as
shown in ScreenLogic.