Pentair Intellitouch ScreenLogic - Manual (Page 29)

19
IntelliTouch ScreenLogic User’s Guide
Wireless router and Protocol adapter with existing Indoor Control Panel (option)
In some cases the homeowner will already have an existing IntelliTouch Indoor Control Panel. The four-
wire conductor cable used to connect to the ScreenLogic Protocol adapter can tap in the Indoor Control
Panel’s four-wire connector or cable.
Advantage:
• Can tap into existing IntelliTouch Indoor Control Panel connector or cable
• Minimal Protocol adapter serial cable wiring
• Good wireless coverage to back of home and pool/spa area
Disadvantage:
• Requires Ethernet cable connection to existing wired or wireless router connected to DSL or Cable
modem. This is only required if you plan to access the Internet. Use of the ScreenLogic interface does
not require an Internet connection. See note at bottom of page.
Ethernet (CAT5) cable
connects ScreenLogic
wireless router WAN port to
existing wired or wireless
router port 1-4
Pool
Spa
Ve
ry
strong
Medium
Weak
Existing DSL or Cable
modem
Equipment Pad/Load
Center
Protocol ScreenLogic
Adapter taps into
existing IntelliTouch
Indoor Control Panel and
connects to the wireless
router via Ethernet cable
LIVING ROOM
FAMILY ROOM
STUDY
KITCHEN
Existing wired or
wireless router
Note: For wireless Tablet and PDA interfaces: If the above Ethernet cable pull is not
possible or practical, you can use the Range Extender Kit (P/N 520561) which will
transfer the wireless signal to the room in your home where the wireless Tablet and/or
PDA are primarily used. For more information, refer to page 20 and 86.