Pentair Intellitouch ScreenLogic - Manual (Page 40)

30
IntelliTouch ScreenLogic User’s Guide
Accessing IntelliTouch ScreenLogic Configuration Program
This section describes the Configurator utility dialogs used to configure ScreenLogic. Follow the Configurator utility
dialogs, Steps 1 through 5 to configure ScreenLogic for the installed IntelliTouch equipment. The Configurator utility
should display upon powering up your Tablet, or in-wall Touch Screen. If using a PC/Laptop, you must first run the
setup program on the IntelliTouch ScreenLogic installation CD-ROM, then click on the ScreenLogic icon on the
Desktop to launch the Configurator utility.
Note: Do not run the Configurator utility while using ScreenLogic. Before starting the Configurator Utility,
you must first exit from the ScreenLogic interface.
Installing IntelliTouch ScreenLogic Software on a PC or Laptop (iTC15 Kit only)
To install the IntelliTouch ScreenLogic software on a PC or Laptop:
1. Insert the ScreenLogic CD into your CD-ROM drive, the Setup Wizard should automatically display. If it
does not display, click ScreenLogic.exe on the CD-ROM to start the Setup Wizard.
2. Press Next and follow the on-screen instructions. The ScreenLogic icon will be installed on your desktop.
Start the Configurator Utility on the Tablet or In-Wall Touch Screen
To start the Configurator utility on the wireless Tablet or in-wall Touch Screen:
• Power up the device. If the Configurator utility is not running, double-tap the IntelliTouch ScreenLogic icon on
the desktop. The Configurator utility main screen will display.
• To access the Configurator utility while running ScreenLogic: Press the virtual keyboard button (see page 11)
to display the virtual keyboard. Tap the Ctrl key, then the Q key to close ScreenLogic, then double-tap the
IntelliTouch ScreenLogic icon on the desktop.