Panasonic KX-P8410 - Manual (Page 127)

127
Care and Maintenance
SCSI
If trouble occurs when printing using SCSI, confirm that the ASPI Manager is
installed. If the ASPI Manager is not installed, you must install it. It is assumed that
the Adaptec SCSI host adapter is installed.
■ Windows 3.1 users
Confirm that the SCSI host adapter is installed in your PC
correctly.
In CONFIG.SYS file, check the following setting.
DEVICE = ASPInDOS.SYS (n = 2, 4, 8 etc.)
If this setting does not exist in CONFIG.SYS, reinstall SCSI driver
using EZ-SCSI (refer to the SCSI host adapter users manual).
Confirm that the EZ-SCSI is installed in Windows 3.1. If Adaptec
EZ-SCSI program group does not exist, install SCSI driver using
EZ-SCSI (refer to SCSI host adapter users manual).
After finishing necessary procedure, restart PC and make sure
that the following message appears on your PC.
“ASPInDOS.SYS Installation successful”
Start Windows and confirm that the printer is recognized by PC
using SCSI utility in EZ-SCSI program group or Show
configuration in KX-P8410 Utilities program group.
If the printer is not recognized, please recheck SCSI ID or
terminator settings.
1
2
3
4
5