Using a scsi cable, Scsi connector, P. 35) – Panasonic KX-P8410 User Manual
Page 35: Setup
35
Note for Terminator setting:
B
The printer must be the last device in the chain. The terminator setting of all
other devices in the chain must be off.
Make sure the computer, printer and the other connected
peripheral devices are turned off.
Connect the SCSI cable to the computer’s SCSI connector and
the printer’s SCSI connector.
B
A SCSI-2 board must be installed in the computer.
If you do not have a SCSI-2 board or a SCSI interface cable, you will need to
purchase one from your local computer store or dealer
Make sure the SCSI ID No. of the printer is 1 (default setting).
B
If you have other devices connected to the computer, make sure that each
SCSI device has a different ID No.
B
To change the printer’s ID No., use the ID No. switches (#1, #2, #3) located
on the back of the printer. Also refer to Table 1 on
1
2
3
12
3
4
ON
Setup
Computer’s SCSI
interface connector
Using a SCSI Cable