Perle Systems IOLAN SCS - Manual (Page 364)

Introduction
364 IOLAN SDS/SCS/STS User’s Guide, Version 3.6
2-Port IOLAN
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
3. To change the power pin out, locate the set of three pins associated with the line you want to set
(Line 1 is J4; Line 2 is the set the three pins just to the left of port 2). For the fixed 5V DC
output, jumper pins 1 and 2. For the output to equal the external adapter input, jumper pins 2
and 3.
4. To turn line termination on for Line 1, locate and jumper both J7 and J8 (as shown in the
diagram). To turn line termination on for Line 2, locate and jumper both J11 and J9.
5. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
2-Port IOLAN RJ45 P (Power Over Ethernet)
To change the settings, do the following:
1. Unplug the IOLAN from the electrical outlet and disconnect everything from the box.
2. Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the
case. You should see the following:
3. For the fixed 5V DC output, locate and jumper J220 for Line 1 (as shown in the diagram) and/or
jumper J221 for Line 2.
4. To turn line termination on for Line 1, locate and jumper both J7 and J8 (as shown in the
diagram). To turn line termination on for Line 2, locate and jumper both J209 and J210.
5. Close the IOLAN case by replacing the case lid and the two screws. You can now power it on
with the new settings.
Note: Serial power in is not supported in the SDS2 PoE model.
Power
DIP
Switch
Reset
RJ45
RJ45
Pi
n1
Screw
Screw
J8
J1
1
J9
RJ4
5
J7
Pin1
J4
1
2
DIP
Switch
Reset
RJ45
RJ45
Pi
n1
Screw
Screw
J8
J2
10
RJ4
5
J7
Pin1
J22
0 1
2
J2
09
J22
1