Panasonic Digital Fiber Sensor FX-301 - Manual (Page 34)

101
FX-301
PRECAUTIONS FOR PROPER USE
Fiber
• Mount the fiber head by using the enclosed set of screws.
The tightening torque should be 0.15 N ⅐m or less
• If the fiber head is mounted in places subject to vibrations
or shocks, use a screw-locking adhesive, etc.
• Mount each fiber head as given below.
Mounting FT-Z8 Ⅺ and FT-WZ8Ⅺ
< FT-Z8 / FT-WZ8 (Front sensing type) >
In case of tapping the mounting section
< FT-Z8E / FT-WZ8E (Side sensing type) >
In case of tapping the mounting section
In case of using attached screw and nut
In case of using attached screw and nut
< FT-Z8H / FT-WZ8H (Top sensing type) >
In case of tapping the mounting section
In case of using attached screw and nut
• Using M3 pan head
screws, the tightening
torque should be
0.3 N
⅐m or less.
Mounting FT-Z802Y
< If not using the attached mounting brackets >
• Use M3 or less set screws (cup point), and affix the head
within 15 mm 0.591 in from the tip of the fiber head. Do
not exceed a torque of 0.3 N ⅐m when tightening.
< If using the attached mounting brackets >
• The head can be affixed even without using the set
screws.
• If using the set screws, use M3 set screws (cup point) to
affix and do not exceed a torque of 0.05 N
⅐ m when
tightening.
Mounting FD-WKZ1
• Using M3 screws, the tightening torque should be 0.3 N⅐m
or less.
Mounting FD-A15
• Using M3 screws, the tightening torque should be 3 N⅐m
or less.
Mounting FD-H30-L32 / FD-H18-L31
08/2005