Panasonic KX-TA308 - Manual (Page 46)

1.5 During a Conversation
1-38 Operations
Placing a Call on Hold (Call Hold)
Allows you to place a call on hold.
Placing a call on hold
PT SLT
Flash the hookswitch. Confirmation tone
and dial tone
During a conversation
Press HOLD. Confirmation tone
and dial tone
HOLD
During a conversation
• The corresponding CO or INTERCOM
indicator light flashes green slowly.
• You may replace the
handset.
• If the handset is replaced, just
off-hook to retrieve the call.
• You may replace the handset.
PT SLT
Flash the hookswitch. Press the CO or INTERCOM
which is flashing green slowly.
CO
or
INTERCOM
At the holding extension At the holding extension
• The CO or INTERCOM indicator light turns
steady green.
Retrieving a call on hold
• To retrieve a call on hold at another extension, refer to “Retrieving a Call on Hold (Call Hold
Retrieve)”.
• If a held call is not retrieved within a pre-determined time (default: 30 sec.), ringing or an
alarm tone will be heard (Hold Alarm/Hold Recall). If the hold recall time is set to “Disable”,
it will not be recalled.
• If a held outside call is not answered within 30 minutes, it will be automatically disconnected.
• When going off-hook:
— Before recalling: A dial tone will be heard while the call is on hold. You may dial
another telephone number.
— While recalling: Only the first call on hold will be released and enter the conversation
mode.
• You cannot hold a doorphone call.
! !