Panasonic KX-TA308 - Manual (Page 63)

1.6 Before Leaving Your Desk
Operations 1-55
Basic Operations
Follow Me
You can set the “Call Forwarding” feature from the destination extension. This is useful if you
forget to set “Call Forwarding — All Calls” before you leave your desk.
Setting
• This feature can be canceled at your extension or the destination extension.
PT and SLT
For a PT: Press
FWD/DND.
For an SLT: Dial 71. Enter your
extension number
(100 through 199). Dial #.
7 1 For an SLT
For a PT
FWD/DND
Dial 5.
extension no. 5
Lift the handset
or press the
SP-PHONE/MONITOR
button. Hang up or
press the
SP-PHONE/MONITOR
button. Confirmation
tone and
dial tone
At the destination extension
#
! !
• You may press the flexible button
assigned as the FWD/DND button
instead.
• The FWD/DND indicator light flashes red
slowly.
• Single line telephone users can dial “0”
instead of “#”.
• If an incoming outside call is forwarded to an outside (CO) line, the “Outside-to-Outside
(CO-to-CO) Line Call Duration Time” is applied to the call and the line will be
disconnected when it expires (default: 10 min.). An alarm tone is sent to both parties
15 seconds before the assigned duration time limit.
• Up to 32 digits (including the line access code) can be programmed.
• If a CPC or reverse signal is sent to an outside (CO) line before the assigned duration time
limit, a call between two external parties will be disconnected.
• This feature cannot be used for incoming outside calls from lines assigned as “Normal”, by
System Programming.
• In the account code verify-all, verify-toll and forced modes, an account code must be stored
by pressing “ ” and entering the account code after the line access code (“ ” is not
regarded as a pause).
! !