System unit selection, Selecting with unit number, Selecting with unit a/unit b button – Panasonic WV-CU360C User Manual
Page 24
24
●
Selecting with UNIT A/UNIT B Button
The unit numbers (01-99) of some frequently used units can
be assigned to numeric buttons 1-9 in the setup. Units can
be divided in two groups, one assigned to the UNIT A and
the other to the UNIT B button. A frequently used system
unit can be easily selected by pressing one numeric button
and then the UNIT A or UNIT B button.
1. Enter a single digit number (1-9).
Omit this step when you wish to select unit number “1”,
as this unit is selected by default.
2. Press the
UNIT A
or
UNIT B
button while the SHIFT
indicator is off.
The selected unit address appears in the unit section of
the LED display.
The selected camera number appears in the camera
section of the LED display.
■
System Unit Selection
Connected system units can be selected either by their unit
number (01-99) or by a single-digit number (1-9) assigned
to the UNIT A or UNIT B button.
●
Selecting with Unit Number
1. Enter a unit number (01-99) with the numeric buttons.
2. Press the
SHIFT
button to turn the shift indicator on,
then press the
UNIT A/UNIT
button.
The selected unit number appears in the unit section of
the LED display.
The selected camera number appears in the camera
section of the LED display.
Notes:
• To confirm the selected unit number when the moni-
tor number appears in the unit section of the LED
display, take procedure 2 or press MON/ESC but-
ton .
• If no unit is connected, [Err] appears a few seconds
after unit selection. In such a case, confirm the unit
address and repeat the above procedure.
• If the unit address of a system unit is unknown, con-
sult your system administrator.
• When multiple system units such as Data Multiplex
Unit are connected to the System Controller and the
UNIT A or UNIT B button is pressed, the camera
number on the controller's LED display will not
agree with the camera picture on the monitor.
In this case, select the monitor and camera as
described on the next page.
MON
CAM
LOGOUT
ESC
SET
SHIFT
UNIT A
then
UNIT
MON
CAM
LOGOUT
ESC
SET
UNIT A
or
UNIT
UNIT B