Camera patrol learning – Panasonic WV-CU360C User Manual
Page 36
36
■
Camera Patrol Learning
There are two ways of setting up camera patrol learning.
One is to use the camera setup menu and the other is to
operate the camera.
Follow the procedures below to set up while operating the
combination camera.
1. Select the desired system unit, monitor and combina-
tion camera.
2. Press the
PATROL PLAY/PATROL LEARN
button
while holding down the
PROGRAM/CAM SETUP/CAM
FUNCTION
button.
[LEARNING] appears on the monitor.
3. Operate the camera using the following controls so that
it traces a routine course most frequently patrolled. The
learning is programmed for 30 seconds for later patrol
play.
• Pan/Tilt (Joystick)
• Iris (Open/Close)
• Focus (Far/Near)
• Zoom (Tele/Wide)
• Preset Position
Note:
The memorized parameters may differ somewhat
depending on the camera type. Refer to the manual
included with the camera.
4. To stop the learning, press the
SEQUENCE/PATROL
STOP
button while holding down the
PROGRAM/CAM
SETUP/CAM FUNCTION
button.
[LEARNING] disappears from the monitor.
7. Move the cursor to [SPECIAL] on the Setup menu, and
press numeric buttons
4
and
6
simultaneously for 2
seconds or more to display the special menu.
8. Move the cursor to [CAMERA RESET]* on the Setup
menu, and press buttons
4
,
5
and
6
simultaneously to
reset all the functions to the defaults.
*
The menu to reset the camera functions differs depend-
ing on the camera:
[SPECIAL] for the WV-CS650, [SPECIAL 2] for the WV-
CS854, and [END] for fixed cameras etc.
Notes:
• If camera setup is started using the buttons on the
camera, all future operations for setup must be per-
formed using the buttons on the camera.
If camera setup is started using the System
Controller, all future operations for setup must be
performed using the same controller.
• For further information, refer to the Operating
Instructions for the selected camera.
Keys used for camera setup
LEARNING
2
8
4
6
To move the cursor
To select a parameter
To execute the mode or
enter a submenu
To return to the previous menu
CAM
SET
MON
ESC
CAM FUNCTION
CAM SETUP
PROGRAM
CAM FUNCTION
CAM SETUP
PROGRAM
PATROL PLAY
PATROL
LEARN
SEQUENCE
PATROL
STOP