Panasonic CPC-EX - Manual (Page 118)

Chapter 5. Peripheral Equipment Section 300-Installation
5-24 DBS Manual - Revised April 2000 DBS-2.3/9.2-300
Table 5-10. Switch settings for abbreviated dialing digit length, VAU
3. Remove the cable punch-out plate (Figure 5-12) to make an opening for
the cable coming into the VAU.
To remove the plate, cut the grooves on either side with diagonal shears.
Then bend the plate back and forth with needle-nose pliers to remove it.
Figure 5-12. Cable punch-out plate, Voice Announce Unit
4. Mount the VAU on the wall using the three screws provided with the unit.
(See Figure 5-14.)
5. Connect the extension cable from the DBS to CN1 on the VAU.
Note: The two inside pins on CN1 are port 1. The two pins on either side
are port 2, as shown in Figure 5-13.
Switch Block 2 (SW2)
Abbreviated Dialing Digit Length (Switches 7-8)
Switch Number of Digits
1 Digit 2 Digits 3 Digits
7 OFF OFF ON
8 OFF ON OFF