Panasonic CPC-EX - Manual (Page 125)

Section 300-Installation Chapter 5. Peripheral Equipment
DBS-2.3/9.2-300 DBS Manual - Revised April 2000 5-31
Door Box Adaptor (Extension Port)
Note: There are two types of door phone adaptors available for the DBS. The
first type (VB-43701) utilizes a trunk connection to connect to the door box.
See “Door Box Adaptor (Trunk Port)” on page 5-27 for more information.
The second type (VB-43711) utilizes a digital port extension to connect to the
door box and door opener and is described below.
Guidelines
• The Door Box Adaptor (VB-43711) requires a door opener. In addition, a
Door Box (door phone) (VA-43705) is normally used with the Door Box
Adaptor. The door opener is not sold by Panasonic; it can be purchased
separately from an electronics dealer.
• Each Door Box and opener use one extension port.
Installation
1. Remove the cover from the Door Box Adaptor.
2. Remove the cable punch-out plate (Figure 5-17) in order to make an
opening for the cables coming into the Door Box Adaptor. To remove the
plate, cut the grooves on either side with diagonal cutters. Then bend the
plate back and forth with needle-nose pliers to remove it.
Figure 5-17. Cable punch-out plate, Door Box Adaptor
3. Mount the Door Box Adaptor on the wall using the three screws provided
with the unit.