Polycom 1725-31402-001 - Manual (Page 48)

Release Notes - UC Software Changes
Page 40 Copyright © 2011 Polycom, Inc.
2.5 Version 3.2.5
2.5.1 Added or Changed Features

59000: Phones now ignore BLA dialog documents sent within NOTIFY messages
that are reflected to User Agents that are party to the dialog.

62939: Various enhancements to the Geo-Redundancy (multiple server fail-over
support) feature. For full details, refer to the list of documents in Section 0.

64359: Bridged Line Appearance BLA line dialog rendering is now converted
from "No" to "Yes" on User Agents that are a remote party to the dialog.
2.5.2 Removed Features
N/A
2.5.3 Corrections

54219: SoundPoint IP 560/670: Phones do not establish a data link when
connected to some switches when both phone and switch are configured for
100Mbits/Full Duplex.

57570
: A “fail-over” is now performed as a result of a SIP Response code 503.

60851: Dialing using the Speaker or Headset key drops the initial call
appearance. An extra missed call is logged. Then, the ringing and ring-back tones
start again.

60973: Entering a username and password using the “Quick Setup” (Qsetup) soft
key followed by a request to save, does not automatically invoke the phone to
reboot the phone in order to the changes to be applied.

61248: After configuring a phone with 3 line registrations, while the 2nd line is on
hold, if a user hot-dials using the speaker/headset termination key, the phone
inadvertently seizes line 3 to dial out.

61283: When a user attempts to place a conference call on hold and the phone
receives a 400 Bad request. The phone then incorrectly sends a NOTIFY with
<param pname="+sip.rendering" pvalue="no" />.

61541: When a user attempts to place a conference on hold and the phone
receives a 400 Bad request, the phone incorrectly sends a NOTIFY with
“pvalue=no”. This causes the incorrect presence, on the other Bridged Line
Appearance line, to be displayed.

62206: SoundPoint IP 320, 321, 330, 331, 335: Phone displays “Service
Unavailable” upon lifting the handset and pressing the Line 2 key. The Line 2 key
is configured as a Speed Dial.

62226: Phones proceed to join a conference afte r receiving a “403 Forbidden”
from the switch.

62383: SoundPoint IP
601: A held call on a remote phone‟s Bridged Line
Appearance is not presented.