Polycom 1725-31402-001 - Manual (Page 88)

Release Notes - UC Software Changes
Page 80 Copyright © 2011 Polycom, Inc.

48039: BLF : Phone plays the „Attendant Ring-Tone‟ instead of the „Regular
Ring-
Tone‟ if the remote line and local phone are both „Ringing‟ and the
remote line is answered and then put on Hold.

48046: On G.729ab gateway calls speaker phone volume is not loud enough
for low level signals

48076: BLF: Attendant phone does not automatically get placed on Hold if a
BLF or speed dial key is used to dial whilst an active call is in process on the
attendant phone. Only occurs if call.
stickyAutoLineSeize=”1”.

48123: SoundStation IP 4000/6000/7000: Clock time does not increment while a
call is active if the idle browser is enabled.

48171: De-registration attempts do not authenticate and so fail to de-register
some lines.

48280: SoundStation IP 6000, 7000: When using TFTP or FTP as the
provisioning Server Type, phone does not save directory entries locally when
TFTP or FTP server is not available.

48385: VVX 1500: SSRC header field is not correct for RFC2833 packets.

48462: SoundPoint IP 501: Ring LED indicator continues flashing even when
the call is answered if an INVITE with “sendonly” SDP is received by the
phone.

48485: VVX 1500: Audio call recording during video calls may fail with certain
USB drives.

48577: SoundPoint IP 430: Default headset gains not correctly set which may
result in poor audio quality with certain headsets.

48591: VVX 1500: Click-to-Hold does not work correctly.

48605: call.stickyAutoLineSeize is not applied correctly when a line is ringing
and SilentRing is selected

48615 : If call.StickyAutoLineSeize=”1”: Transfer fails if attempted whilst a
second call is alerting.

48667: If there is an incoming call while there is an existing outgoing call in the
proceeding state, the phone will not audibly alert the user for the incoming call

48668: 401 Authentication challenge to a VQMon PUBLISH may cause the
phone to reboot.

48672: Received volume on the handset is lower than desired for low input
signal levels. Addressed by adding 4dB gain at low input levels on the
handset. Gain at high input levels is unchanged.

48685 In SIP 3.1.2 the MWI NOTIFY must have the message summary for the
MWI LED to be lit.

48697: An incoming call without Caller ID Name but with Caller ID Number is
matched with the first local contact that has Name blank.

48699: TelURI doesn't process "tel://*50"