National Instruments PC-LPM-16/PnP User Manual
Page 123
Index
©
National Instruments Corporation
I -5
PC-LPM-16/PnP User Manual
interrupt selection
PC-LPM-16, C-9 to C-10
disabling interrupts (figure), C-10
IRQ5 factory setting (figure), C-10
PC-LPM-16PnP, 2-3
I/O connector
exceeding maximum ratings
(warning), 4-1
pin assignments (figure), 4-2
J
jumper settings.
See
configuration.
L
LabVIEW and LabWindows/CVI application
software, 1-2 to 1-3
M
M<2..0> bits, D-23
MA<3..0> bits, D-5 to D-6, D-34
manual.
See
documentation.
MSM82C53 Counter/Timer integrated circuit.
See also
Counter/Timer
(MSM82C53) Register Group.
data acquisition timing, 3-9
data sheet, B-1 to B-12
timing I/O circuitry, 3-9
multichannel data acquisition, 3-7
multiple A/D conversions, programming
on single input channel using
Counter 0, D-30 to D-32
using external timing, D-33 to D-34
with channel scanning, D-34 to D-35
multiplexer, input, 3-5
N
NI-DAQ driver software, 1-3 to 1-4
O
operation of PC-LPM-16PnP.
See
theory of
operation.
OUT signal
counter block diagram, 3-10
general purpose timing and
counter timing, 4-9 to 4-12
timing specifications for OUT
output signals, 4-11 to 4-12
OUT0 signal (table), 4-4
OUT1 signal (table), 4-4
OUT1* signal (table), 4-3
OUT2 signal (table), 4-4
OVERFLOW bit
description, D-13
register-level programming, D-28,
D-32, D-34
OVERRUN bit, D-13
P
PC I/O channel interface circuitry, 3-3 to 3-4
block diagram, 3-3
PC-LPM-16
compared with PC-LPM-16PnP,
C-1 to C-3
characteristics (table), C-1 to C-2
performance specification changes
(table), C-2 to C-3
configuration. See configuration.
installation, C-12
PC-LPM-16PnP.
See also
theory of operation.
custom cables, 1-5 to 1-6
features, 1-1
optional equipment, 1-5
requirements for getting started, 1-2
software programming choices, 1-2 to 1-4
LabVIEW and LabWindows/CVI
application software, 1-2 to 1-3
NI-DAQ driver software, 1-3 to 1-4
register-level programming, 1-4
unpacking, 1-6
physical specifications, A-4