National Instruments PC-LPM-16/PnP User Manual
Page 125
Index
©
National Instruments Corporation
I -7
PC-LPM-16/PnP User Manual
power rating (table), 4-8
signal descriptions (table), 4-3 to 4-4
timing connections, 4-8 to 4-12
data acquisition timing
connections, 4-8 to 4-9
general purpose timing
signal connections, 4-9 to 4-12
single-channel data acquisition, 3-7
software installation, 2-2
software programming choices, 1-2 to 1-4
LabVIEW and
LabWindows/CVI application
software, 1-2 to 1-3
NI-DAQ driver software, 1-3 to 1-4
register-level programming, 1-4
specifications
analog input, A-1 to A-2
ADC errors (figure), A-6
amplifier characteristics, A-2
differential nonlinearity, A-5
dynamic characteristics, A-2
explanation, A-4 to A-6
input characteristics, A-1
integral nonlinearity, A-5
relative accuracy, A-4 to A-5
stability, A-2
system noise, A-5
transfer characteristics, A-1 to A-2
bus interface, A-4
digital I/O, A-2 to A-3
environment, A-4
physical, A-4
power requirements, A-4
timing I/O, A-3
square wave generation, 4-9
Status Register 1, D-10 to D-12
Status Register 2, D-13
switch settings.
See
configuration.
system noise, A-5
T
technical support, E-1 to E-2
theory of operation
analog input circuitry, 3-5 to 3-6
block diagram, 3-4
block diagram, 3-2
data acquisition timing circuitry,
3-6 to 3-7
block diagram, 3-5
data acquisition rates, 3-7
multichannel scanning
data acquisition, 3-7
single channel data acquisition, 3-7
digital I/O circuitry, 3-8
functional overview, 3-1
PC I/O channel interface circuitry,
3-3 to 3-4
block diagram, 3-3
timing I/O circuitry, 3-9 to 3-10
counter block diagram, 3-10
time-lapse measurement, 4-10
Timer Interrupt Clear Register, D-24
timing connections, 4-8 to 4-12
data acquisition timing connections,
4-8 to 4-9
general purpose timing
signal connections, 4-9 to 4-12
pins, 4-8
timing I/O circuitry, 3-9 to 3-10
counter block diagram, 3-10
timing I/O specifications, A-3
two's complement format, 3-5
U
unipolar input selection 1 (0 to 10 V), C-11
unipolar input selection 2 (0 to 5 V), C-12
unpacking the PC-LPM-16PnP, 1-6
UP function, support for (note), D-35