Optional equipment, Custom cables, Optional equipment -5 custom cables -5 – National Instruments PC-LPM-16/PnP User Manual

Page 16

Advertising
background image

Chapter 1 Introduction

National Instruments Corporation

1-5

PC-LPM-16/PnP User Manual

Optional Equipment

National Instruments offers a variety of products to use with your
PC-LPM-16/PnP board, including cables, connector blocks, and other
accessories, as follows:

•

Cables and cable assemblies, shielded and ribbon

•

Connector blocks, shielded and unshielded with 50-pin screw

terminals

•

SCXI modules and accessories for isolating, amplifying, exciting,

and multiplexing signals for relays and analog output. With SCXI
you can condition and acquire up to 3,072 channels.

•

Low channel-count signal conditioning modules, boards, and

accessories, including conditioning for strain gauges and RTDs,
simultaneous sample-and-hold circuitry, and relays

For more specific information about these products, refer to your
National Instruments catalogue or call the office nearest you.

Custom Cables

National Instruments currently offers a cable termination accessory, the
CB-50, for use with the PC-LPM-16/PnP. This kit includes a
terminated, 50-conductor, flat ribbon cable and a connector block.
Signal input and output wires can be attached to screw terminals on the
connector block and connected to the PC-LPM-16/PnP I/O connector.

The CB-50 is useful for the initial prototyping of an application or in
situations where PC-LPM-16/PnP interconnections are frequently
changed. Once you develop a final field wiring scheme, however, you
may want to develop your own cable. This section contains information
and guidelines for the design of custom cables.

The PC-LPM-16/PnP I/O connector is a 50-pin, male, ribbon cable
header connector. The following list gives recommended part numbers
for use with your PC-LPM-16/PnP board:

•

Electronic Products Division/3M (part number 3596-5002)

•

T&B/Ansley Corporation (part number 609-5007)

a.Book : e.chapter 1 Page 5 Wednesday, November 20, 1996 6:36 PM

Advertising