Nortel Networks NN44200-300 - Manual (Page 27)

Removing the front bezel and server cover 27
What is next?
Remove the server cover so that you can inspect the interior of the server.
See
"Removing the front bezel and server cover" (page 27) .
Removing the front bezel and server cover
Introduction
To access the server interior, you must remove both the front bezel and
the server cover.
Two locked doors, located on the front of the server, cover the front panel,
including the CD-ROM drive and tape drive. These doors are part of the
front bezel. You must unlock the front bezel doors before you can remove
the bezel.
To remove the front bezel
Step Action
CAUTION
Do not attempt to move or lift the server before removing the front
bezel; the server can disengage from the bezel and fall.
1 Unlock and open the double doors of the front bezel. See A in the
diagram below.
2 Firmly grasp the front bezel by the hand-holds on either side of the
chassis, and pull the front bezel from the chassis.
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300 01.01 Standard
5.0 23 February 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.