Nortel Networks NN44200-300 - Manual (Page 30)

30 Chapter 3 Preparing for installation
IF THEN
components have become loose secure them.
Refer to the procedures in the
Installation and Configuration
Task List (NN44200-306).
you are satisfied that the 1002rp
server has arrived at your site
undamaged replace the server cover and
proceed with the hardware
installation.
See "Installation checklist" (page
23) .
Note: Do not reinstall the front
bezel until the server is in its
final location and the CallPilot
installation is complete.
—End—
To replace the front bezel after installation is complete
Step Action
When the CallPilot server installation is complete and the server is in its
final location, replace the front bezel.
1 Align the front bezel with the ball studs located at each faceplate
corner.
See the diagram below:
Nortel CallPilot
1002rp Server Hardware Installation
NN44200-300 01.01 Standard
5.0 23 February 2007
Copyright © 2007, Nortel Networks Nortel Networks Confidential
.