Nortel Networks Server 1005r - Manual (Page 18)

18 Chapter 2 1005r server description
Configuration
Card
slot
type
Slot
number
Position Card type
Meridian 1*/
CS* 1000
FS_PCI-1 top MPB96 MGate 1, 2, 3
FS_PCI-2 middle MPB96 MGate 4, 5, 6
Full size
FS_PCI-3 bottom MPB96
Note: 3 Mgate cards connect to 1 MPB96
When cabling to MGate cards, the RJ-45 connectors are numbered from 1 to 3
on the top NTRH40CA MPB96 board and from 4 to 6 on the middle NTRH40CA
MPB96 board starting from the right side of the back panel (next to the power
supplies)
LP_PCI-1 top RAID
LP_PCI-2 middle Dual NIC
Three MPB96
(High Capacity)
Low profile
LP_PCI-3 bottom Dual NIC
Network connectivity
Introduction
This section describes how the 1005r server can be integrated into your
network. The integration depends on the type of switch you are using.
ATTENTION
To secure the CallPilot server from unauthorized access, ensure that the CallPilot
network is inside your organization’s firewall.
Sample network setup: Meridian 1
The following diagram shows a CallPilot server sample network setup with a
Meridian 1 switch. The Meridian 1 switch can be one of the following:
• Option 11C or Option 11C Mini
• Option 51C
• Option 61C
• Options 81 and 81C
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.06 Standard
5.0 15 May 2008
Copyright © 2006-2008, Nortel Networks
.