Nortel Networks Server 1005r - Manual (Page 31)

Connecting peripherals to the server 31
• The two servers are delivered with only one dongle. It does not matter
which server you connect the dongle to until you configure the servers.
For more information about the High Availability feature, see High
Availability: Installation and Configuration (NN44200-311).
Inspecting the modem
Introduction
You require a modem to support remote dial-up access to the CallPilot
server. Nortel technical support also connects to your CallPilot server for
troubleshooting purposes. Nortel connects to your server only when you
request technical assistance.
Required equipment
To install the modem, you need the following equipment:
• USB modem
• RJ-11 analog phone cord
• USB cable (supplied with the modem)
• analog line jack
Serial port modems with RS-232 connections are not supported on the
1005r.
What is next?
Continue with "Connecting peripherals to the server" (page 31) .
Connecting peripherals to the server
Rear panel connectors
The following diagram shows the connectors on the rear panel.
Label Control or feature Label Control or feature
A DB15 Telco alarm connector
(not used) G Rear connection to Comm 2
serial port
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.06 Standard
5.0 15 May 2008
Copyright © 2006-2008, Nortel Networks
.