Nortel Networks Server 1005r - Manual (Page 23)

23
Chapter 3
Preparing for installation
In this chapter
• "Installation overview" (page 23)
• "Unpacking the 1005r server" (page 25)
• "Removing the front bezel" (page 27)
Installation overview
Introduction
This section provides an overview of the steps required to install the 1005r
server and peripheral devices.
Installation checklist
The following checklist identifies the tasks that must be performed when
installing the CallPilot server. For detailed instructions, see
"Installing the
server" (page 29) When you are finished with the installation, continue with
the Installation and Configuration Task List (NN44200-306).
Note: If you are installing a High Availability system, follow this
checklist for each server, with the exceptions listed on
"Installing a High
Availability system" (page 30)
Step Description Check
1 Review the "Installing the CallPilot server" section in the Installation
and Configuration Task List (NN44200-306), and completed stage
1 of the "Installation checklist."
Nortel CallPilot
1005r Server Hardware Installation
NN44200-308 01.06 Standard
5.0 15 May 2008
Copyright © 2006-2008, Nortel Networks
.