Napoleon Fireplaces BGD36CFPTR - Manual (Page 27)

27
W415-0661 / C / 02.20.08
Installation requires a minimum of 6 1/2" non-combustible facing material at the top of the fi replace. Refer to either Figure 86a or Figure
86b (depending on your installation) to ensure your fi replace has been installed with the proper requirements for this kit.
Whether installing to a fi nished fl oor or a hearth, a 3/8" clearance must be maintained at the bottom of the clean face surround kit. To obtain
this clearance a fi replace riser is required.
When installing to a fi nished fl oor the fi replace riser must create a minimum clearance of 3 3/8" from the fi nished fl oor to the bottom of the
fi replace.
WAVE
S36WN (BROWN)
S36WP (PEWTER)
CONCAVE
S36CCN (BROWN)
S36CCP (PEWTER)
CONVEX
S36CVN (BROWN)
S36CVP (PEWTER)
**
OPTIONAL CLEAN FACE SURROUND INSTALLATION BGD36CF(G) ONLY
FIGURE 85 FIGURE 83 FIGURE 84
FIGURE 81
FINISHED FLOOR INSTALLATION
NOTE:
** Installation requires a minimum 6 1/2" of non-combustible
facing above the top of the fi replace.
FINISHED
FLOOR
3 / 8 ”
CLEARANCE
3 3 / 8 ”
CLEANFACE SURROUND
STAND-OFF
6 1 / 2 ” MINIMUM
37 3 / 8 ”
FINISHED
FLOOR
NON-COMBUSTIBLE
MATERIAL
COMBUSTIBLE
MATERIAL
FIREPLACE
RISER 3 / 8 ”
CLEARANCE
3 3 / 8 ”
FIREPLACE
RISER
STAND-OFF
CLEAN FACE
SURROUND
KIT
CLEAN FACE SURROUND KIT
STEEL
HEADER
STEEL
HEADER
FIGURE 82
FIGURE 86a
CLEAN FACE SURROUND MINIMUM ENCLOSURE CLEARANCES