NEC Express5800/120Rh-2 N8100-1126F - Manual (Page 402)

F-16 Installing Windows 2000
Below is the example on how to add /PAE switch to Boot.ini file.
1. Click [Start], point to [Programs], point to [Accessories], and then click [Notepad].
2. On the [File] menu, click [Open...].
3. In the [Open] dialog box, in the [Look in] drop-down list box, click "%systemroot%"
drive.
4. In the [Open] dialog box, in the [Files of type] drop-down list box, click "All Files" and in
the [File name] drop-down list box, enter "Boot.ini". And then, click [Open].
The content of Boot.ini file will be displayed.
5. Add "/PAE" to [Operating Systems] section in [Boot.ini] file, and then save it.
<Example of Boot.ini file>
[boot loader]
timeout=30
default=multi(0)disk(0)rdisk(0)partition(1)\WINNT
[operating systems]
multi(0)disk(0)rdisk(0)partition(1)\WINNT="Windows 2000" /fastdetect
multi(0)disk(0)rdisk(0)partition(1)\WINNT="Windows 2000, PAE" /fastdetect /PAE
This is the end of editing Boot.ini file.
NOTE: If you choose one of the items in the "Default operating
system" drop-down list box in [Setup and Recovery] group box, you
can make your system start automatically from the switch you
specified.
SETTING FOR COLLECTING MEMORY DUMP
(DEBUG INFORMATION)
Set for collecting memory dump using the procedure described in Chapter 5.