National Instruments 5411 - Manual (Page 16)

© National Instruments Corporation 2-1 DAQArb 5411 User Manual
Chapter
2
Installation and
Configuration
This chapter describes how to install and configure your DAQArb 5411.
Installation
Note: You should install your driver software before installing your hardware.
Refer to the DAQArb 5411 Read Me First document for software
installation information.
If you have an older version of NI-DAQ already in your system, that
software will not work with your device. Install NI-DAQ from the NI-DAQ
software CD shipped with your DAQArb 5411.
You can install the PCI-5411 in any PCI slot and the AT-5411 in any ISA
slot in your computer. However, for best noise performance, leave as
much room as possible between the DAQArb 5411 and other hardware.
Before installing your 5411 device, consult your PC user manual or
technical reference manual for specific instructions and warnings.
Follow these general instructions to install your DAQArb 5411:
1. Write down the DAQArb 5411 serial number on the DAQArb 5411
Hardware and Software Configuration Form in Appendix C,
Customer Communication. You may need this serial number for
future reference if you need to contact technical support.
2. Turn off your computer.
3. Remove the top cover or access port to the I/O channel.
4. Remove the expansion slot cover on the back panel of the
computer.
5. For the PCI-5411, insert the card into a PCI slot. For the AT-5411,
insert the card into a 16-bit ISA slot. It may be a tight fit, but do not
force the device into place.
6. Screw the mounting bracket of the DAQArb 5411 to the back panel
rail of the computer.
7. Visually verify the installation.