National Instruments 5411 User Manual
Page 81
Index
© National Instruments Corporation
I-3
DAQArb 5411 User Manual
frequency hopping and sweeping, 4-11
frequency instruction, 4-9
frequency resolution, 4-10 to 4-11
lookup memory, 4-9, 4-10 to 4-11
single trigger mode, 4-13
stepped trigger mode, 4-15
time instruction, 4-9
update rate (note), 4-3
VirtualBench-Function Generator
(note), 4-2
documentation
conventions used in manual, x
organization of manual, ix
E
electronic support services, C-1 to C-2
e-mail support, C-2
equipment, optional, 1-5
external clock reference input
specifications, A-6
EXT_TRIG signal (table), 3-6
F
fax and telephone support, C-2
Fax-on-Demand support, C-2
FIFO, instruction, 4-3
FIFO memory, 4-3
filter characteristics, A-2 to A-3
frequency hopping and sweeping, 4-11
frequency resolution, DDS mode, 4-10 to 4-11
FTP support, C-1
H
hardware configuration, 2-2
I
installation and configuration
hardware configuration, 2-2
installation procedure, 2-1 to 2-2
installing optional memory module, 2-2
unpacking DAQArb 5411, 1-6
instruction FIFO, 4-3
internal clock specifications, A-6
I/O connector, 3-1 to 3-6
ARB connector, 3-2
Dig Out connector, 3-4 to 3-5
illustration, 3-1
pin assignments (figure), 3-5
PLL Ref connector, 3-3 to 3-4
SYNC connector, 3-3
L
LabVIEW software, 1-3
LabWindows/CVI software, 1-3
linking and looping. See waveform linking and
looping.
lookup memory, DDS mode
frequency generation process, 4-10
loading cycles of waveforms,
4-10 to 4-11
restrictions, 4-9
synthesizing arbitrary waveforms,
4-10 to 4-11
M
manual. See documentation.
marker offset, in stages, 4-6
marker output signal, 4-16 to 4-18
generated marker positions (table), 4-17
markers as trigger outputs (figure), 4-17
specifications, A-5
MARKER signal (table), 3-6
master/slave operation, 4-23 to 4-24