NetComm 5330 - Manual (Page 65)

5330/5340 IP Phones – User Guide
Direct Paging - Handsfree Answerback Disabled
Your administrator enables or disables Handsfree Answerback and you can also turn it on or off
on your phone. To turn Handsfree Answerback off, see "Direct Paging - Handsfree Answerback
Enabled" elsewhere in this guide. When Handsfree Answerback is disabled on your phone and
you receive a Direct Page, the Direct Page is indicated by a single burst of tone.
To answer Direct Page calls when Handsfree Answerback is disabled:
Phone state before Page arrives: To answer the Direct Page
(indicated by single burst of tone):
Phone is idle and MUTE is OFF. 1. Check that MUTE is ON solid.
2. Lift the handset OR press MUTE key to answer in
Handsfree mode. (The light turns OFF.)
3. Begin speaking.
You are on a handset call or
headset call, and MUTE is OFF 1. Check that MUTE is flashing.
2. Press MUTE. The light turns ON solid and and you are
now speaking to the paging party and have MUTED your
handset/headset call.
3. Speak to the paging party. Press MUTE to alternate
between handset and handsfree calls.
You are on a MUTED
handset/headset call, OR, you are
on a Handsfree call The party paging you receives a busy tone. Handsfree
Answerback does not interrupt your call.
To end a Direct Page call, do one of the following:
• Hang up the handset to end a handset call.
• Press
(SPEAKER) to end a Handsfree call.
• Press (CANCEL).
When the Handsfree Direct Page call ends, the (MUTE) key light returns to the state it was in
before the call was established.
65