NetComm 5330 - Manual (Page 67)

5330/5340 IP Phones – User Guide
67
EMERGENCY CALLS WHEN EMERGENCY CALL ROUTING NOT PROGRAMMED
If Emergency Call Routing is NOT programmed, Emergency Number dialing should only
be performed by picking up the handset and selecting the Analog Line key you have
programmed. If Privacy Mode is enabled and the Analog Line key local line is busy, dialing
will not occur on the Line Interface Module line. Emergency dialing using an IP connection
may not be supported due to ICP system configuration and country location. For more
information, contact your System Administrator.
To make an Emergency Call using the Line Interface Module line:
1. Lift the handset.
2. Press the Analog Line key that you have programmed.
The set indicates ANALOG CALL
3. Dial your Local Emergency Number.
To make an Emergency Call using the Line Interface Module line, when the IP connection has
failed:
1. Lift the handset.
2. Press the Analog Line key that you have programmed.
The set indicates IP FAIL: ANALOG CALL.
3. Dial your Local Emergency Number.
EMERGENCY CALLS WHEN EMERGENCY CALL ROUTING PROGRAMMED
Note: This procedure is in addition to the methods described above.
To make an Emergency Call if Emergency Call Routing is programmed:
1. Lift the handset.
2. Dial your Local Emergency Number (911 or equivalent).
For more information on using the Line Interface Module line, refer to Using the Line Interface
Module.