NetComm SmartVoice Gateway - Manual (Page 21)

SmartVoice Gateway(s) User Guide 21
YML832 Rev1
Setting Dynamic IP (DHCP)
Click “DHCP” to obtain a Dynamic IP address, and then click the “Accept” button at the bottom of the
screen.
To save the settings click System Operation to select “Save Settings”, “Restart”, and then click the
”Accept” button. Wait for a while (about 40 seconds), and the system will obtain the related IP value from
the DHCP Server.
NOTE: After the system has obtained a new IP address, if using WAN Port to enter
the Web Configuration Screen, a new IP address has to be used. The same applies
to the following two settings.
Setting Static IP
Select “Static IP” and enter the IP address, Subnet Mask and Default Gateway values. Then click the
“Accept” button at the bottom of the screen.
Save the settings, and then restart the system. Wait for about 40 seconds for the system to restart.
ADSL PPPoE Settings
Select “PPPoE” and enter the Account Number, Password and re-enter Password to confirm. Then click
the “Accept” button at the bottom.
Save the settings, and then restart the system. The system will take about 40 seconds to restart.