NetComm SmartVoice Gateway - Manual (Page 23)

SmartVoice Gateway(s) User Guide 23
YML832 Rev1
LAN interface mode
• Router: The system serves as a router.
• Bridge: The system serves as a bridge between WAN port and LAN port. (LAN default gateway will
still be accessible for configuration).
Network Settings (LAN)
• Network Settings (LAN): The gateway’s LAN IP address and subnet mask value. Please note that
the gateway is built under NAT: The gateway’s LAN IP address cannot be in the same section as
the Internet sharing devices, or else it is unable to make or receive calls. For example, if the LAN IP
address of the Internet sharing device is 192.168.8.1, then the gateway’s LAN IP address cannot be
in the range between 192.168.8.1 ~ 192.168.8.254. If it is, please change the LAN IP address of
the gateway (e.g. set the IP address to 192.168.99.254 instead).
• Enable DHCP Server: Enable or Disable DHCP server service of gateway.
• IP Pool Starting Address: The first IP address to be assigned to DHCP clients.
• IP Pool ending Address: The last IP address to be assigned to DHCP clients.
• Lease Time: The valid period of an assigned IP address.
• Domain Name Server Assignment: The DNS information to be assigned to DHCP clients.
Auto : Assigns the same DNS information of WAN port to the DHCP clients.
Manual : Manually assign the DNS information for DHCP clients.
• Port of Web Access from WAN: Http port for WAN. To make this setting, the web configuration
must be performed via the gateway’s LAN port. The gateway always uses port 80 for Http
connections via LAN ports of the gateway.
NOTE: For network security concern, Web Access for WAN port is disabled by
default (port number “0” in this option means disable the Web Access). To enable
it simply type in a valid port number in this field.