National Instruments E Series - Manual (Page 37)

 National Instruments Corporation 4-1 DAQCard E Series User Manual
Signal Connections
Chapter
4
This chapter describes how to make input and output signal connections
to your DAQCard E Series card via the DAQCard I/O connector.
The I/O connector for the DAQCard E Series cards has 68 pins that you
can connect to 68-pin accessories with the PSHR68-68M and SH6868
shielded cables, or the PR68-68F ribbon cable. With the PSHR68-68M
and SH6868 shielded cables or the PR68-50F ribbon cable, you can
connect your DAQCard to 50-pin signal conditioning modules and
terminal blocks.
I/O Connector
Figure 4-1 shows the pin assignments for the 68-pin I/O connector on
the DAQCard-AI-16E-4 and DAQCard-AI-16XE-50. A signal
description follows the connector pinouts.
Warning: Exceeding the differential and common-mode input ranges distorts your
input signals. Exceeding the maximum input voltage rating can damage
the DAQCard E Series card and your computer. National Instruments is
NOT liable for any damages resulting from such signal connections. The
maximum input voltage ratings are listed in Tables 4-2 through 4-3 in the
Protection column.
This document was created with FrameMaker 4.0.4