Nortel Networks Application Server 53r 5300 00 - Manual (Page 33)

Hardware configuration 33
with the correct memory configuration but not recognized by the
system. If this happens, contact your next level of support before
proceeding.
3 Select Advanced Setup.
4 Select RSA-II Settings.
5 Select Restore RSA II Defaults.
Network settings for the RSA-II card are restored to factory
defaults. Any existing network connections to the RSA-II
Ethernet interface are disconnected and no further connections
can be made until network settings are reconfigured.
When the reset to factory defaults is complete, the following
message appears:
RSA II Defaults Loaded!
If data had been previously configured for the RSA-II card, that
data appears.
6 Press Enter.
7 Press Esc until the top level menu of the planar BIOS setup
utility appears.
8 Select Load Default Settings.
The following message appears:
Current settings will be changed to their default
settings - Press Enter to continue.
9 Press Enter.
The planar BIOS is restored to the factory defaults.
10 Select Exit Setup.
11 Select Yes, save and exit the Setup Utility and press Enter.
The server reboots.
--End--
Resetting the ServeRAID BIOS to factory defaults
Use this procedure to reset the ServeRAID BIOS to the factory default
settings.
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
Copyright © 2007-2008 Nortel Networks
.