NetComm NB1300 Plus 4W - Manual (Page 77)

Rev. 1 - YML672 www.netcomm.com.au
NB1300_2 ADSL Modem Page 77
Testing the Path from Your Computer to a Remote Device
After verifying that the LAN path works correctly, test the path from your computer to a
remote device.
From the Windows run menu, type:
PING -n 10 <IP address>
where <IP address> is the IP address of a remote device such as your ISP’s DNS server.
If the path is functioning correctly, replies as in the previous section are displayed. If you do not
receive replies:
■ Check that your computer has the IP address of your ADSL Modem listed as the default
gateway. If the IP configuration of your computer is assigned by DHCP, this information
will not be visible in your computer’s Network Control Panel. Go to the Run… window and
run winipcfg. Verify that the IP address of your ADSL Modem is listed as the default
gateway.
■ Check to see that the network address of your computer (the portion of the IP address
specified by the netmask) is different from the network address of the remote device.