National Instruments SCXI-1120 - Manual (Page 100)

SCXI-1120 Cabling Appendix E
SCXI-1120 User Manual E-2 © National Instruments Corporation
Table E-1 lists the pin equivalences of the MIO-16 board and the SCXI-1120.
Table E-1. SCXI-1120 and MIO-16 Board Pinout Equivalences
Pin SCXI-1120 Rear Signal Connector MIO-16 Board
Equivalent
1-2 AOGND AIGND
3 MCH0+ ACH0
4 MCH0- ACH8
5 MCH1+ ACH1
6 MCH1- ACH9
7 MCH2+ ACH2
8 MCH2- ACH10
9 MCH3+ ACH3
10 MCH3- ACH11
11 MCH4+ ACH4
12 MCH4- ACH12
13 MCH5+ ACH5
14 MCH5- ACH13
15 MCH6+ ACH6
16 MCH6- ACH14
17 MCH7+ ACH7
18 MCH7- ACH15
19 OUTREF AISENSE
24, 33 DIG GND DIG GND
25 SERDATIN ADIO0
26 SERDATOUT BDIO0
27 DAQD*/A ADIO1
29 SLOT0SEL* ADIO2
36 SCANCLK SCANCLK
37 SERCLK EXTSTROBE*
43 RSVD OUT1
No other pins are connected on the SCXI-1120.
SCXI-1340 Installation
Follow these steps to install the SCXI-1340:
1. Make sure that the computer and the SCXI chassis are turned off.
2. Install the SCXI module in the chassis.
3. Plug the mounting bracket connector onto the module rear signal connector (see Figure E-1).
Make sure the alignment tab on the bracket enters the upper module guide of the chassis.
4. Screw the mounting bracket to the threaded strips in the rear of the chassis.