National Instruments SCXI-1120 - Manual (Page 15)

Chapter 1 Introduction
© National Instruments Corporation 1-3 SCXI-1120 User Manual
You can also use the SCXI-1120, combined with the NB Series data acquisition boards, with
NI-DAQ software for Macintosh. NI-DAQ software for Macintosh, which is shipped with all
National Instruments Macintosh data acquisition boards, comes with language interfaces for
MPW C, THINK C, Pascal, and Microsoft QuickBASIC. Any language that uses Device
Manager Toolbox calls can access NI-DAQ software for Macintosh.
Optional Equipment
Equipment Part Number
SCXI-1320 front terminal block 776573-20
SCXI-1328 high-accuracy isothermal terminal block 776573-28
SCXI-1330 32-pin connector-and-shell assembly 776573-30
SCXI-1340 cable assembly 776574-40
SCXI-1341 Lab-NB/Lab-PC/Lab-PC+ cable assembly 776574-41
SCXI-1342 PC-LPM-16 cable assembly 776574-42
SCXI-1343 rear screw terminal adapter 776574-43
SCXI-1344 Lab-LC cable assembly 776574-44
SCXI-1346 shielded multichassis cable adapter 776574-46
SCXI-1347 SCXI shielded cable assembly
with 1 m cable
with 2 m cable
with 5 m cable
with 10 m cable 776574-471
776574-472
776574-475
776574-470
SCXI-1349 SCXI shielded cable assembly
with 1 m cable
with 2 m cable
with 5 m cable
with 10 m cable 776574-491
776574-492
776574-495
776574-490
SCXI-1350 multichassis adapter 776575-50
SCXI process-current resistor kit 776582-01
Standard ribbon cable 0.5 m
1.0 m 180524-05
180524-10
NB6 cable
0.5 m
1.0 m 181305-01
181305-10
Refer to the Signal Connections section in Chapter 2, Configuration and Installation, and to
Appendix E, SCXI-1120 Cabling, for additional information on cabling, connectors, and
adapters.