Data acquisition board setup programming – National Instruments SCXI-1120 User Manual
Page 77
Programming
Chapter 5
SCXI-1120 User Manual
5-6
© National Instruments Corporation
1. Data Acquisition Board Setup Programming
The programming steps for your data acquisition board are given in your data acquisition board
user manual. You should follow the instructions in the following sections:
•
AT-MIO-16 User Manual
-
Multiple A/D Conversions with Continuous Channel Scanning (Round Robin)
-
Multiple A/D Conversions with Interval Channel Scanning (Pseudosimultaneous)
•
AT-MIO-16D User Manual
-
Multiple A/D Conversions with Continuous Channel Scanning (Round Robin)
-
Multiple A/D Conversions with Interval Channel Scanning (Pseudosimultaneous)
•
AT-MIO-16F-5 User Manual
-
Posttrigger Data Acquisition with Continuous Channel Scanning
-
Posttrigger Data Acquisition with Interval Channel Scanning
•
AT-MIO-16X User Manual
-
Continuous Channel Scanning Data Acquisition
-
Interval Channel Scanning Data Acquisition
•
AT-MIO-64F-5 User Manual
-
Continuous Channel Scanning Data Acquisition
-
Interval Channel Scanning Data Acquisition
•
Lab-LC User Manual
-
Programming Multiple A/D Conversions with Channel Scanning
•
Lab-NB User Manual
-
Programming Multiple A/D Conversions with Channel Scanning
•
Lab-PC User Manual
-
Programming Multiple A/D Conversions with Channel Scanning
•
Lab-PC+ User Manual
-
Programming Multiple A/D Conversions with Channel Scanning
-
Programming Multiple A/D Conversions with Interval Scanning
-
Programming Multiple A/D Conversions in Single-Channel Interval Acquisition Mode