Nortel Networks HotWire 8600 - Manual (Page 41)

Installing and Connecting the Hardware
2-25 8600-A2-GN20-20 October 1997
Connecting to an SNMP Management System
"
Procedure
To connect the HotWire 8600 DSLAM base chassis (i.e., the chassis that contains
the MCC card) to an SNMP management system:
1. Plug the end of an 8-pin modular cable into the MANAGEMENT MCC port of
the HotWire 8600 DSLAM base chassis.
2. Dress the 8-pin cable under the 8600 chassis to the left and behind the left
support foot.
3. Plug the other end of the cable into the 10BaseT hub connector to the SNMP
management system network.
Refer to Appendix B, Pinouts , for pin assignments.
97-15376-02
LAN/WAN SLOT
2
A
IN
B
DC PWR
OUT SERIAL MCC 1
MANAGEMENT
3
A
AC
INPUT
AC
48VDC CLASS 2 OR LIMITED PWR SOURCE
RTN 48V
A A B B
T5A
250V
LAN/WAN SLOT
2
4 6
B
..
. 3
. 1 2
POSITION STACK
ALM A
IN
B
DC FUSES t4a, MIN. 48V 5
DC PWR FAN
OUT SERIAL MCC 1
MANAGEMENT
3
LINE
1
2
3
SYSTEM
OK Alrm Test TX RX Col
ETHERNET MCC 8000
SYSTEM
OK Alrm Test TX RX Col 1 2 3 4
ETHERNET DSL
POR
T
RADSL 8546
SYSTEM
OK Alrm Test TX RX Col 1 2 3 4
ETHERNET DSL
POR
T
RADSL 8546
To SNMP
Management System